We just got 10 N2048P and we were going to try one of them in the current enviroment before deploying all of them, unfortuntaly we got those errors in the log:
Apr 28 09:58:08 SW-SPES-06-1 DRIVER[bcmDPC]: broad_hpc_drv.c(4428) 366 %% Unit: 0 #012 CDC RX FIFO entry 44 double-bit ECC error
Apr 28 09:58:08 SW-SPES-06-1 DRIVER[bcmDPC]: broad_hpc_drv.c(4428) 367 %% Unit: 0 #012 CDC RX FIFO table 0 entry 44 ECC error
Apr 28 09:59:50 SW-SPES-06-1 DRIVER[bcmDPC]: broad_hpc_drv.c(4428) 369 %% Unit: 0 #012 CDC RX FIFO entry 28 double-bit ECC error
our network monitor says that some of the devices attached are losing pings every now and then (even if we can't see any packet loss with a manual ping) and it gets this error from the switch via SNMP:
CRIT - [Unit: 1 Slot: 0 Port: 22 Gigabit - Level] (up) MAC: f8:b1:56:62:b2:fa, 10MBit/s, in: 57.19B/s, in-errors: 2.78%(!!) = 0.1, out: 4.68kB/s
Note that the device attached to the port 22 is NOT one that gave us warnings about pings
I've seen here that someone got the same problem on the same switch and it could be related to a memory problem, I upgraded the firmware from 6.1.0.6 to 6.2.0.5 but no luck, I decided to try another switch but I got the same problem (i copied the configuration), so it seems that the problem is not really related to the switch.
Before the N2048P we were using a small Netgear Prosafe FS116P without any apparent problem (it is unmanaged tho), any though on what it could be or on how can it debug the problem?
