Hello, I have two PowerConnect 3524 switches that I want to setup VLANs on. I want to have 3 VLANS: 1xOffice; 1xWifi; 1xOther. I want all three to be separate without the ability communicate with each other, but they all need internet access.
I have setup one VLAN for now (on SwitchB) and connected two ports/computers to it. Currently, the rest of the network is still on VLAN1. The two computers on VLAN 2 are seeing all computers on the network and have internet access.
My SwitchA has a very simple setup:
- fa0/1 = trunk (to the router/firewall)
- g3 = general (to SwitchB)
- GVRP enabled on g3 for "state", "dynamic vlan configuration", and "gvrp registration"
My SwitchB is also simple:
- g4 = general (to SwitchA)
- e19 = general VLAN 2
- e22 = general VLAN 2
- GVRP enabled on g4 for "state", "dynamic vlan configuration", and "gvrp registration"
I have been using the web-interface only.
I was expecting/hoping that the two computers on VLAN2 would see each other and have internet access, but not see the other computers on the network. I was also expecting to see VLAN 2 get created on SwitchA but that is not happening either.
Any suggestions on how to fix this? Many thanks.