Hello,
while I was doing some changes to the configuration, I accidentally removed the only untagged Vlan 1 port I had. Now I don't know how to access the management web page again... I tried to change the vlan id on the ethernet port using the serial port, but it seems like a lot of CLI commands are missing on this switch model. For example after using:
interface ethernet g16
I don't have any commands available except end, exit, help.
I also tried to change assign the ip address to my main vlan, but it says it can be assigned only to vlan 1.
Any suggestions? I want to avoid the factory reset of the switch if possible...