Hello everyone
I am trying to make 4 switches form a stack but with no luck so far. I believe I follow the steps correctly but I really don't know why the rest of them do not add themselves to the stack. If anyone has some spare time, please have a look at the steps I take below:
1. The cables I use are SFP 10G. The ports I want to use are 1/0/3 and 1/0/4. I can confirm that the cables are plugged in correctly to form a ring topology.
2. Power on switch 1 (the one I want it to be the master) and access the switch using hyperterminal.
3. After a minute or two I power on the next switch and then the rest of them.
3. go into 'operational mode' and start the 'setup wizard'. I then create an admin account, and setup vlan1. I enter the IP, subnet and GW
4. Then I follow the steps shown in this link: http://www.dell.com/Support/Article/us/en/19/HOW10800
5. After I run 'reload', I reboot all the switches but they all become unit 1.
I don't know what I am doing wrong here. Any suggestions please?