Hi, All,
I got a dell x4012 switch and would like to use it in a lab environment. I plan to script the running-config via SSH, to dynamically add or remove interfaces from a given vlan. However, to my surprise, I cannot find "switchport" command under interface configuration.
When I try to the configuration from the GUI, it works fine. And the"switchport" command configuration shown in running-config, e.g. after I did the config from GUI, then check it via SSH with "show run inter te1/0/6", it shows "switchport access vlan 300" under te1/0/6. However, if I try to type the same command under interface configuration, the command line interface complained unknown command. I'm not sure if this is a bug, or there are some other places I have enable it? I'm running the latest firmware 3.0.0.91
Best Regards
Daniel