I installed a Dell switch and can access the internet and everything seems fine but I cannot access anything on the routers network. My routers main network is 192.168.1.x and the router is at 192.168.1.1 I have this coming into a Dell x1052 on port 47 which is configured as an access port on vlan 1. What am I doing wrong? Here is the x1052 config below.
DHCP SERVER
| Pool Name | Network Mask | Address Pool Start | Address Pool End | Lease Duration | Number of Leased Addresses | |
|---|---|---|---|---|---|---|
| Production | 255.255.255.0 | 10.0.0.100 | 10.0.0.199 | 1d:0h:0m | 2 |
VLAN
| Interface | IP Address Source | IP Address | Subnet Mask | |||
|---|---|---|---|---|---|---|
| VLAN2 | Static | 10.0.0.1 | 255.255.255.0 | |||
| VLAN4 | Static | 10.10.0.1 | 255.255.255.0 | |||
| VLAN3 | Static | 172.16.0.1 | 255.255.255.0 | |||
| VLAN1 | Static | 192.168.1.2 | 255.255.255.0 |
IPV4 Routes
Destination IPv4 Prefix | Prefix Length | Next Hop | Route Type | Route Owner | Metric | Edit | ||
|---|---|---|---|---|---|---|---|---|
| 0.0.0.0 | /0 | 192.168.1.1 | Remote | Default | 1 | |||
| 10.0.0.0 | /24 | Local | Directly Connected | |||||
| 172.16.0.0 | /24 | Local | Directly Connected | |||||
| 192.168.1.0 | /24 | Local | Directly Connected |
ARP
dns is set to 192.168.1.1
dhcp option
dns is 192.168.1.1
default router 10.0.0.1
BTW I can access the x1052 from 192.168.1.2, 10.0.0.1, and 172.16.0.1
----
okay so update since the last post, I enabled management of the router from 255.255.255.255 and I can now access 192.168.1.1 the router IP from the 10.0.0.0 network although I still cannot see any other devices on the 192.168.1.1 network.