Hi,
We have configured a stack of 2 switches Dell MXL 10/40G by executins the following commands on each of them.
Dell#show system stack-unit 0 stack-group
Stack group Ports
------------------------------------
0 0/33
1 0/37
2 0/41
4 0/49
Dell#configure
Dell(conf)#stack-unit 0 stack-group 0
Dell(conf)#stack-unit 0 stack-group 1
Dell(conf)#exit
Dell#reload
But when we execute the command "show system brief" it shows that one switch is only online.
Dell#show system brief
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
------------------------------------------------------------------------------------
0 Management online MXL-10/40GbE MXL-10/40GbE 9.11(0.0) 56
1 Member not present
2 Member not present
3 Member not present
4 Member not present
5 Member not present
And the stack-ports was added successefully but the Link is down
Dell#show system stack-ports
Topology: Stand alone
Interface Connection Link Speed Admin Link
(Gb/s) Status Status
---------------------------------------------------------
0/33 40 up down
0/37 40 up down
I would like to know if our config is right or no and if this problem can be caused by a bad cable knowing that the PN of te two used cables used is dac-qsfp-40g-1m.
Thank you.
