Hi there!
i've two switches Dell PC5524, and i want to create portchannel between them.
The configuration of two switches are as below:
SW01:
!
interface vlan 5
name USERS
!
interface vlan 6
name SERVERS
ip address 192.168.6.1 255.255.255.0
!
interface gigabitethernet1/0/1
channel-group 1 mode on
switchport mode trunk
switchport access vlan 6
!
interface gigabitethernet1/0/2
channel-group 1 mode on
switchport mode trunk
switchport access vlan 6
SW02:
!
interface vlan 5
name USERS
!
interface vlan 6
name SERVERS
ip address 192.168.6.2 255.255.255.0
!
interface gigabitethernet1/0/1
channel-group 1 mode on
switchport mode trunk
switchport access vlan 6
!
interface gigabitethernet1/0/2
channel-group 1 mode on
switchport mode trunk
switchport access vlan 6
Before, the ports gi1/01 and gi1/02...were part of vlan 6.
now, i tried to remove that configuration:
switchport access vlan 6
BUT I CAN NOT DELETE IT.
i tried again, when i put the configuration
channel-group 1 mode auto.
If i use only one port, with no portchannel configuration, and make it run in trunk mode, the two switches communicate normally with each other.
Now, what is my problem? and how can i fix it?
Regards!