I have a single Dell Powerconnect N3024p it is configured in L2 mode and is configured with 3 VLANS. VLAN 1 the default is configured on ports 21 - 24, Vlan 10 is configured on ports 1-14, and VLAN 200 on ports 15 - 20. All ports are currently access ports and the ports only belong to one vlan. Port 1 (vlan 10) is connected to my firewall router on port 1 which is also configured as an access port for vlan 10. I have desktops and servers connected to switch ports 2 - 14, and everything works great there. switch port 15 is connected to firewall port 2 which is configured as access port vlan 200. Here is where I have trouble.
I am using my firewall / router (juniper srx) to route the traffic between vlans and out to another location via site to site vpn. From vlan 10 (any device on my switch), I can ping my vlan 10 gateway address on my router, my vlan 200 gateway address on my router and I can ping addresses across my wan. but I can not ping anything on ports 15 - 20(vlan 200) on my dell switch. Devices on ports 15-20, and ping each other but not the VLAN 200 gateway on the router nor any other ip address. I have confirmed that there is nothing wrong with the patch cable and have tried the same configuration, but using different switch ports. I am at a loss as to what is going on. Why does vlan 10 work and not vlan 200.
If anyone has any insight, suggestions, etc. I would appreciate it.