Hello all,
I initially configured the switch such that the ports were set to access mode.
Subsequently, we decided to set them to trunk mode.
When checking the switchport settings (see below for example port configuration) I was surprised to see Access Mode VLAN: 10 .
Logically, I want to remove this, since a port set to access mode belongs to only one VLAN.
However, the behaviour of our storage network suggests that it is behaving correctly.
I have tried to remove it, but have been unsuccessful.
Could someone provide me with the command to do so please?
Is the Access Mode VLAN: 10 setting benign? Or is it suppressed by the trunk mode setting?
I look forward to being enlightened.
Thank you very much in advance,
G.
[snip]
Port: Te1/0/1
VLAN Membership Mode: Trunk Mode
Access Mode VLAN: 10
General Mode PVID: 1 (default)
General Mode Ingress Filtering: Enabled
General Mode Acceptable Frame Type: Admit All
General Mode Dynamically Added VLANs:
General Mode Untagged VLANs: 1
General Mode Tagged VLANs:
General Mode Forbidden VLANs:
Trunking Mode Native VLAN: 1 (default)
Trunking Mode Native VLAN Tagging: Disabled
Trunking Mode VLANs Enabled: 10,30,40
Private VLAN Host Association: none
Private VLAN Mapping:
Private VLAN Operational Bindings:
[/snip]