I just got a 7048p put in my lap to setup for a project. I don't know the entire previous history of the unit - so I powered it on - plugged a few cables into it to see if it would pass traffic (it does) - and hooked it up to my network to see if the OOB port would pull a DHCP address (it does).
I have it hooked up to a Digi terminal server on the administrative port, I can get to the Openmanage login page thru the DHCP addressed OOB port - and I can telnet to the switch at the DHCP address.
But I can't get into the thing. The major problem I think is that I get no response out of the admin port when I connect to it. The manual says that the initial username/password info must be set thru the Cli - so I'm guessing that without that happening first - there's no way I'm logging in thru the Openmanage web GUI - or thru a telnet session - is that correct?
Is there some default Openmanage user/pass I can use?
I believe I have the Digi port settings correct:
Port Profile: Console Management
Baud Rate: 9600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
I am using a regular CAT5 cable to go from the Digi port to the 7048 admin port. I do get a response indicating I am connecting with the client I'm using (SecureCRT)
I'm looking for any suggestions on how to get a response out of the CLI on this unit. - Thanks!