I have two N30xx switches at two different locations running as layer 3 switches. Both are performing well as routing switch running static and ospf..
However, I cannot access the switches such as ping or telnet the switches using its vlan IP addresses outside of the local networks. I can access withing its networks (i.e. both my computer and the switch on the same subnet)
I have a few 6248 switches and checked configuration and don't seem to have anything missing. Is it something I am missing or I must use the Out of Band interface to access the switch?
Both switches are running firmware 6.1.2.4. Belwo is a traceroute from one of the switches trying to access a host on the network.
netxxxswtdc01#traceroute 10.10.10.10
Traceroute to 10.10.10.10 ,30 hops max 0 byte packets:
1 0.0.0.0 * * *
2 0.0.0.0 * *
Hop Count = 2 Last TTL = 2 Test attempt = 5 Test Success = 0
Thanks a lot!
John