Hi all
I got a dell mxl switch for my that I inputed the wrong command for, now I am trying to undo it but I can't figure out how.
What happened was this:
I inputted this:
interface range tengigabitethernet 0/1 – 32
...other config...
then I did this:
interface range tengigabitethernet 1/1 – 32
on the same switch. I shouldn't have done that.
Now running-config shows these guys:
interface TenGigabitEthernet 0/56
no ip address
flowcontrol rx on tx off
shutdown
!
stack-unit 1 provision MXL-10/40GbE
!
stack-unit 1 port 41 portmode quad
!
stack-unit 1 port 45 portmode quad
!
stack-unit 1 port 49 portmode quad
!
stack-unit 1 port 53 portmode quad
!
interface TenGigabitEthernet 1/1
no ip address
flowcontrol rx on tx off
shutdown
!
interface TenGigabitEthernet 1/2
no ip address
flowcontrol rx on tx off
shutdown
I tried to delete the startup-config and reload but these are still there afterwards.
Thanks