Hi Guys,
Was wondering if someone could help me here, a little confused on how to get this configured correctly.
I have a PowerConnect 6248 which I am trying configure.
I have two vlans, the default vlan id 1 which is preconfigured and a vlan 200 which I have created. My issue is that I need the switch to do the vlan routing for me. I have another router that does the vlan routing for me, but because that router interface is only 100mb, my vlan transfer speeds at bottlenecked by this 100mb interface (seperate router). I would like to completely not use the router for the purposes of local vlan routing and make the powerconnect do all the routing itself.
Here is a dump of the current config. A mess, yes I know, but I have been busting my kneecaps trying to figure it out and cannot find the solution. Would someone be kind enough to help me out here. I understand that the management vlan needs to change from vlan 1 if I want to do vlan routing. This is part of my issue of trying to configure this correctly.
Cheers..
SW1#show run
!Current Configuration:
!System Description "PowerConnect 6248, 3.3.3.3, VxWorks 6.5"
!System Software Version 3.3.3.3
!Cut-through mode is configured as disabled
!
configure
vlan database
vlan 200
vlan routing 200 1
exit
hostname "SW1"
stack
member 1 2
exit
ip address 192.168.2.5 255.255.255.0
ip default-gateway 192.168.2.5
ip routing
interface vlan 200
name "ManagementVLAN"
routing
ip address 192.168.200.5 255.255.255.0
ip netdirbcast
ip mtu 1500
exit
