Hello Everyone;
Overview:
My ISP provided me with more than Public IP block i.e (192.158.13.1/24, 192.158.14.1/24) that I would like to assign to my Hypervisor (Citrix XenServer) via vLAN isolation & make it accessible to my VMs to acquire public IPs directly. (this is actually a requirement of the network I'm setting up).
I would like to know if this scenario is possible to implement via Dell 6224 L3 Switch.
Network Setup:
- My ISP gave me one link feed to my rack that I'm using (I can assign any IP from both different blocks) that I was given.
- Currently the ISP link going to my Dell Power Connect 6224 L3 Switch port 24 then going to my XenServer box port 15
- I have number of vLANS Setup on the switch that are represented to the XenServer therefore port 15 is trunk port.
What I'm trying to do
Since all VMs requires public IPs .
1. on Dell Switch create 2 vlans 10 & 20
2. Assign public ip to each vlan
3. create route rule on the switch to foreword the traffic to ISP router
4. Add vLAN 10 & 20 to port 15 so my XenServer hypervisor can see the incoming traffic.
My Current Status
i'm unable to to have this working in this order can someone advice if the idea is correct to achieve this task or I have to design different solution for this to work.