Hi
I have 2 x N4032 Switches and 7 N2048 edge switches
Each switch has an uplink port to 1 of the N4032 switches
2 Vlans configured
Uplink ports are configured as Trunk Ports, and all ports on the N4032 are configured as Trunk Ports
My issue is that only some devices get ip addresses, and not all devices can be contacted even once they get an ip address
If I remove the N4032 Switches, and daisy chain the 7 switches using only the Access Ports (for that vlan) everything works fine
RST is configured on all ports
There are no errors in the logs either so i am very very confused