We are using the information provided from the following document: i.dell.com/.../dell-networking-n4000-series-switch-configuration-guide-for-equallogic-sans.pdf
We have two N4032F switches that are stacked and have pretty much followed this document word for word. We are not using DCB. We are trying to configure a LAG and followed step 2.11 in the document but it appears the LAG is not working.
Switch 1:
interface range fortygigabitethernet 1/1/1-2
no spanning-tree portfast
channel-group 1 mode active
Switch 2:
interface range fortygigabitethernet 2/1/1-2
no spanning-tree portfast
channel-group 2 mode active
However, when we view after changing these settings it shows them as inactive.
Can anyone please assist?
Thanks,
Jeff