I'm just starting to work w/a new 4032F with dual power supplies (both powered). After issuing a reload command I get this:
Reference platform resetting ...
syncing filesystems....This may take a few moments
Rebooting system!
The system is going down NOW!
Sent SIGTERM to all processes
Sent SIGKILL to all processes
Requesting system reboot
And then it just sits: nothing after 10 minutes and counting. Facing the rear of the switch, if I remove power to the right-side power supply it reloads immediately. If I provide power to only the left-side unit it will reload but if I provide power to only the right-side unit it still hangs. Perhaps I'm misunderstanding the nature of redundant power here. Suggestions?