Hi,
I am swapping out a old Linksys switch that has our phones and I am looking to VLAN our phones and PCs on the 6248P switch.
I have setup the 6248P to have VLAN1 as PC's and VLAN101 as the Voice. Tagged 101 on the port 40 which I am testing and left VLAN1 as untagged.
I have enabled Voice VLAN and assigned the VLAN ID to 101 then on the port settings change VLAN mode general and assigned PVID to 101.
Port 47 is the trunking port and I have set this as the trunk port however the phone does not get a IP Address from the Cisco 800. I am just changing the link from the Linksys to the dell to test but it does not work.
Can you advise me on the settings the for Trunk and if that's correct on what I have done.
I am quite a newb on networking but hopefully it makes sense above
