We've got an M8024-k switch installed in our Dell blade chassis. I'm trying to get igmp snooping to work on a VLAN without much success. Software version appears to be 5.1.5.1. Commands described in docs I've found via the Dell site or Google don't work. I've poked at it and I think I'm close but while the switch says that the interface mode is enabled, the operational status shows non-operational:
Interface Interface-Mode Operational-Status
--------- -------------- ----------------
Vl1 Disabled Non-Operational
Vl101 Enabled Non-Operational
The manuals say you should be able to go into interface mode for the vlan and enter the command ip igmp snooping but that is not a valid command:
feldstack-blade1(config-if-vlan101)#ip igmp ?
<cr> Press enter to execute the command.
last-member-query-count Configure last member query count.
last-member-query-interval Configure last member query interval.
query-interval Configure IGMP query interval.
query-max-response-time Configure maximum query response time.
robustness Configure IGMP router robustness.
startup-query-count Configure startup query count.
startup-query-interval Configure startup query interval.
version Configure IGMP or IGMP Proxy version.
When I generate multicast traffic from a VM behind this switch, I never see the group in the list of known groups, even though I see the group and mroutes come and go further up stream of this on my Cisco 6500 that is the mrouter for the vlan.
Anyone have any luck getting something like this working? Any ideas where I can get the config manual for 5.1.5.1?
Thanks.
Mike