Hi all,
I got some problems with VLAN on a Dell X1026 switch.
I configure 4 ports as general ports, with Pvid=50 (tagged with id 50) and member of vlan 50 tagged and vlan 1 as untagged.
According to page 140 of the manual, if the device transmit untagged, the switch performs tagging and traffic egress is tagged with vlan id = 50.
I attached two untagged devices to these ports but I can't ping in neither direction (ip addresses manualy assigned).
I tried to config the ports as access with Pvid=50 and I can ping in both directions, but with general ports it doen't seem to work, even if I set general mode with a sigle vlan id.