OK I cannot seem to get this to work. I am trying to connect a N3048P to two S4810 switches. One I try it seems to lose connection. I have a couple n3048P stacks that I have connected to the same S4810 switches for redundancy without issue. I am not sure what is different with these switches. All I can think of is that only one port is being used on each of the stack members to connect to the s4810 switches. eg. Stack1 SW1 goes to TOR1 and Stack1 Sw2 gores to TOR2.
I have one of the 10Gb ports on the N3048P connected to one of the ports of the S4810 switch. That works fine. The S4810 switches are connected together using VLT.
What I originally did was connect port 1 of the N3048P to a port on the S4810 switch. Then assigned it a port channel of 108. I then connected port 2 of the N3048P to a port on the second S4810 switch and assigned it to a port channel of 108.
Would that be correct?