We have several 5524P and some 5548P switches. All of them non-stacked powering up Aruba AP105.
We started to replace them today with AP325 and run into problems. This switch has 15 AP105. We replaced the first five without issues. But when we replaced the sixth, it wouldn't power at all.
At first we thought it was a patch cable issue, Did cable testing and everything is showing fine. But neither the new AP nor the old one would power up then.
I kept checking different ports and eventually I found another empty one that would power up the AP. Config is straight forward (single vlan). Tried to play with LLDP settings, but nothing. Updated firmware.
After rebooting, one port came back, but the others one didn't. Power consumption shows each port that works at about 6w. Total power consumption is 91 watts out of 500.
Bad switch? I have a spare and will try to replace it. Just doesn't make any sense... Do I need to configure LLDP-MED options?
TIA.
