Hello,
We have one N2024P that apparently fails to deliver power over PoE. I haven't tested the device myself but I have received reports that PoE device connected to any of the ports won't power up.
If I check the inline power status the switch reports it's off.
sw# show power inline | include ^Pow
Power.......................................... Off
Power Management Mode.......................... Dynamic
Power Detection Mode........................... dot3at+legacy
The switch appears to see PoE controller at least:
sw# show power inline firmware-version
Unit Firmware Version
---- ----------------
1 265_1
How could I inverstigate this further? I see nothing PoE related in the logs. I didn't find any way to disable or enable PoE the switch globally.
Best regards,
Matti
