Dell M1000e + MI/O Aggregator port mapping

Hi All,

I was planning to setup a new Dell M1000e chassis along with Dell M I/O Aggregator. During the solution time I have few queries about mapping the Physical uplink ports with Blade NDC ports. Can any one please check the config below and clarify my queries ?

My Hardware :

• 1x Dell M1000e
• 2x M I/O Aggregator  ( A1 & A2)  
• 16x M630 Blade ( Qlogic 57840S Quad-port CNA Card)

DELL M I/O Aggregator :

2-port QSFP+ module (Reserved for Future Use) (Port No1:33-36 & Port No2:37-40)

I want to use these two modules for my blades which required 4 Quad ports and the confusion which I had, how to map these 16 ports ( 8 ports from each module) to the Blade servers and how much band width I will get per blade along with redundancy.

4-port SFP+ 10GbE module ( Flexi Bay O) (Port No:41-48) 

4-port 2/4/8Gb FC FlexIO module ( Flexi Bay 1) (Port No:49-56)

FYI - I would like to install ESXi 6.0 on all Blades

Thanks!!

Vinay