Hi All,
I replaced Cisco switch with Dell s4048 switches recently. There are 2 dell s4048 switch with stack configuration and 2 connection from each Equallogic controller to each switch. Switch ports are configured with VLAN (Untag) and 9216 as MTU the only difference between Cisco switch and dell is Cisco have 1 GB ports and dell have 10GB ports.
I believe port throughput suppose to be auto negotiated and work fine but it is not working, when I move LAN cable to Cisco it works fine.
Do we need any special configuration to make connection establish between 1GB Equallogic port and 10 GB Dell S4048 port?
Looking forward if any one had same issue or any further solution. I am contacting Dell support too but still do not get any reply.
Kind regards
Binaya