Hi All,
I am new to this forum kindly help me with below issue.
We brought new Dell M1000e chassis with M I/O Aggregator switches, switch1 and 2.
each switch have 2 X 40 gig ports total 80 gig per side , switch-1 80 gig and switch-2 80 gig, these switches connected with 40 gig cables which got split in to 4 10gig cables and goes in to patch panel and from there to upstream switch.
I got upstream connection from CISCO nexus 5k, network team configured port-channel,
i am trying to configure these switches in PMUX mode,
I configured port-channel but port-channel status is down and mode is L3, how to bring the status active and mode to L2 ?
i provided how in configured with command below please help me.
========================================
Dell(conf)#interface range tengigabitethernet 0/33-34
Dell(conf-if-range-te-0/33-34)#no shutdown
Dell(conf-if-range-te-0/33-34)#port-channel-protocol ?
lacp Enable LACP port-channel protocol
Dell(conf-if-range-te-0/33-34)#port-channel-protocol lacp
Dell(conf-if-range-te-0/33-34-lacp)#port-channel 40 mode active
Dell(conf-if-range-te-0/33-34-lacp)#interface port-channel 40
Dell(conf-if-po-40)#no shutdown
Dell(conf-if-po-40)#end
Dell#show interfaces port-channel brief
Codes: L - LACP Port-channel
O - OpenFlow Controller Port-channel
A - Auto Port-channel
I - Internally Lagged
LAG Mode Status Uptime Ports
L 40 L3 down 00:00:00
