Hi,
I am trying to configure Dell M IO Aggregator my self need some guidance.
I am seeing below details when i run show running-configuration on M IO Aggregator, i was referring dell document it says this are showing when there is a split cable with 40 gig.
stack-unit 0 port 33 portmode quad
!
stack-unit 0 port 37 portmode quad
!
stack-unit 0 port 41 portmode quad
!
stack-unit 0 port 45 portmode quad
!
stack-unit 0 port 49 portmode quad
!
stack-unit 0 port 53 portmode quad
!
but when we check show lldp show lldp neighbors , the upstream interfaces i see Te 0/33,0/34,0/36,0/37,0/38,0/39,0/40 ports on the switch. i am confused could you please explain this.
other thing when i compare both switches with running-configuration i can see some difference.
switch 1
interface TenGigabitEthernet 0/1
mtu 12000
portmode hybrid
switchport
vlan tagged 39
flowcontrol rx on tx off
!
protocol lldp
no shutdown
!
switch 2
interface TenGigabitEthernet 0/1
mtu 12000
portmode hybrid
switchport
vlan tagged 39
!
protocol lldp
no shutdown
!
on switch 1 i see flowcontrol rx on tx off , but not on switch 2 do we need this option on both or it should not be please help me
Thank you.
| Te 0/33 |
| Te 0/34 |
| Te 0/36 |
| Te 0/37 |
| Te 0/38 |
| Te 0/39 |
| Te 0/40 |