In I have a M1000e chassis with two M8024-K switches, and one of them came to give problems and we temporarily put an M8024 switch to replace an M8024-K that presented problems, however we are working with 10 Gb interfaces, in this switch we just Install (M8024) is communicating with the blades at 1 Gb, the setting is in "Auto Trading".
I noticed that from my Ethernet Switch until the Switch M8024 is 10 Gb however the Switch to the Blade comes to 1 Gb, we have already changed the configuration of the switch to 10000 Full on the ports and interface of the host esxi, however there was no success.
Would they have a solution?
