We have purchased some N2048P switches and I am in the process of setting them up. I have setup radius with a 2 factor authentication service that we pay for and the push to my phone works fine and I get logged into the switch. My questions are:
1) What line of code do I need to use on these switches to put myself in the Privileged EXEC mode when logging in. I am having to type my local enable password after I get connected.
2) The same for the web interface. I have added ip http authentication radius local and that of course does a push to my phone for 2 factor authentication but after I get logged in I get a message saying I am in basic mode and it states, "Please note that you are level 1 and do not have configuration privileges. This session is limited to read only operations."
I have been at this off and on for a few days and can't find the syntax to make this work. Thanks!