N2048P delete PoCs

Hi there,

is there any possible way to remove the empty port-channel. IMHO it is a bit weird that the switch shows 128 PoCs that are empty and not used?

I.e. those show up via snmpwalk

sw-H4-UG(config)#do show version

Machine Description............... Dell Networking Switch
System Model ID................... N2048P
Machine Type...................... Dell Networking N2048P
Serial Number..................... XXXXXXXXXXXXXXXXXXXXXXXXXXX
Manufacturer...................... 0xbc00
Burned In MAC Address............. F8B1.5657.44B8
System Object ID.................. 1.3.6.1.4.1.674.10895.3056
SOC Version....................... BCM56340_A0
HW Version........................ 5
CPLD Version...................... 13

unit active backup current-active next-active
---- ----------- ----------- -------------- --------------
1 6.3.2.7 6.1.2.4 6.3.2.7 6.3.2.7

sw-H4-UG(config)#show interfaces po

Channel Ports Ch-Type Hash Type Min-links Local Prf
------- ----------------------------- -------- --------- --------- ---------
Po1 No Configured Ports Static 7 1 Disabled
Po2 No Configured Ports Static 7 1 Disabled
Po3 No Configured Ports Static 7 1 Disabled
Po4 No Configured Ports Static 7 1 Disabled
Po5 No Configured Ports Static 7 1 Disabled
Po6 No Configured Ports Static 7 1 Disabled
Po7 No Configured Ports Static 7 1 Disabled
Po8 No Configured Ports Static 7 1 Disabled
Po9 No Configured Ports Static 7 1 Disabled
....

Regards

Manuel