Hello,
We have an older 3524 switch that we recently reset and need to configure from scratch. I am able to telnet into the switch with putty and I deleted the startup config and reset the switch. I followed the setup wizard and set an ip address for vlan 1 along with an snmp community string. The switch is currently not on network, it is directly connected to an off-network laptop for configuration. The laptop is plugged into port 1. From what I understand, all ports are in vlan 1 by default. My problem is, after configuring the initial settings I still cannot access the GUI. I made sure the laptop nic was set to the same subnet as the switch. Any suggestions? Any help is greatly appreciated.