Hi,
My first time dealing with Power Connect as I have mostly dealt with Cisco switches. I am trying to get to the boot special menu through the serial connection. I am connected through what I use with Cisco serial cable console cable: 9600, 8, N. I see the start up fine but as I hit ESC or return no action other than the switch continues to boot and then stuck with the following message:
******************************************************************
*** Running SW Ver. 1.1.0.42 Date 11-Jan-2004 Time 12:50:35 ***
******************************************************************
HW version is 00.00.02
Base Mac address is: 00:0f:1f:3a:df:21
Dram size is : 32M bytes
Dram first block size is : 20M bytes
Dram first PTR is : 0xB20000
Flash size is: 8M
STAND ALONE
The BCM5625_A1 0 initiate successfully
The BCM5625_A1 1 initiate successfully
01-Jan-2000 01:01:13 %SSHD-W-NOHOSTKEY: SSH has been enabled but an encryption k
ey was not found.
For key generation use the 'crypto key generate' commands. The service will sta
rt automatically when a host key is generated.
01-Jan-2000 01:01:14 %INIT-I-InitCompleted: Initialization task is completed
authentication failed
Hit any key...