I have a PowerConnect 2708 that I would like to reset back to factory settings.
It shows it is in managed mode, but I can't get to the web interface.
I'm not sure what the current IP of the switch is. I I connect a laptop to it that is set to DHCP, and I do an ipconfig, I come back with an IP Address on the laptop of 169.254.8.x, and a subnet mask of 255.255.0.0, but it doesn't show a gateway.
I tried to take it out of managed mode, then put it back in, but that didn't seem to work.
What should I try next?
Thanks,
Rob