I had a 48v Valuepoint Access point hooked into port 24 using POE with no problem. Just replaced it with a new Ubiquiti access point (24v) and when I do a show power inline, the status on port 24 is "Fault". I never seen this and can't find the answer anywhere. Any ideas??
I realize that the priority goes to the lower port when priority is the same and I already tried setting the priority to high, I reloaded the switch and enabled and disabled the port.
Unit Power Nominal Power Consumed Power Usage Threshold Traps
---- ------- ------------- ------------------ --------------- ---------
1 On 370 Watts 14 Watts (4%) 95 Disable
Port Powered Device State Status Priority Class
------- -------------------- -------- ------------ -------- ---------
e1 Never Off low class0
e2 Never Off low class0
e3 Never Off low class0
e4 Never Off low class0
e5 Never Off low class0
e6 Never Off low class0
e7 Never Off low class0
e8 Never Off low class0
e9 Never Off low class0
e10 Never Off low class0
e11 Never Off low class0
e12 Never Off low class0
e13 Never Off low class0
e14 Never Off low class0
e15 Never Off low class0
e16 Never Off low class0
e17 Never Off low class0
e18 Never Off low class0
e19 Auto On low class0
e20 Auto On low class0
e21 Never Off low class0
e22 Auto On low class0
e23 Never Off low class0
e24 Auto Fault low class0