I'm trying to get traffic to route through an S4810 and PC6248 to allow communication between 1GB and 10GE devices.
The S4810's are connected to the 10GE uplink modules in the rear of the PC6248's.
S4810 Config:
TE 0/0 0/1 configured into Port-Channel 1 -> connect to PC6248 uplink module
VLAN 100 - Port-Channel 1 tagged
IP address on int VLAN 100 - 10.100.100.1/24
PC6248 Config:
1/xg3 1/xg4 configured into Channel-Group 1 - trunk allowing VLAN 100
IP address on int VLAN 100 - 10.100.100.2/24
VLAN 100 IP routing enabled
Any device directly connected to S4810 can ping 10.100.100.1, and any device directly connected to PC6248 can ping 10.100.100.1. But you can ping across the 2 switches.
Any ideas/suggestions?