Hello. I updated my Dell 5424 Init file to run on the 6224 however I still cannot access the GUI (even after allowing http). I tried to route the managment port per a previous suggestion but that did not work either ? Any suggestions ? Thanks.
exit
enab
conf
user admin pass dellswitch lev 15
no span
vl dat
vl 4444
ex
int eth 1/g3
spanning-tree disable
sw mode gen
sw gen all vl add 4444
sw gen acc tag
sw gen pvid 4444
sw gen allowed vlan add 4444
sw gen allowed vlan remove 1
ex
int vl 4444
ip add 192.10.120.2 /26
ex
ip http server
ex