I just got a new 1052P. Installed it into the rack, plugged it in. Went through the setup wizard and gave it a name and IP. Then put my computer back onto the normal network settings, plug into the switch and cannot log in via the GUI.
So, naturally, I try the console port. I noticed that the name of the switch is one number higher than what I originally named it. When I try to enable, the password I set is not accepted.
Is there something I'm missing? I set it up as DHCP just to make sure it "switches", everything worked. I need it to be managed so I can make my Cisco phones work on it, amongst other items.
What is it I am doing wrong?