N3048 Web Interface Access Without OOB
I have recently had our switch replaced via RMA and have access to the web interface via oob. I am unsure of how to get access from other ports and subnets and would like access to the web interface...
View ArticleX1052P Switch question
This may be a silly question, but will the X1052P Switch work with Cisco 7940 series and 7912 phones?Thanks!
View ArticleSImple Routing Question On 6224
This should be a simple routing issue on 6224. Just trying to get a route set between vlan 40 and vlan 50. Ping is intermittent sometimes it goes through and sometimes it is 50% and sometimes it gives...
View ArticleHow to configure Power Connect 55xx/54xx or any power connect switch without...
How to configure Power Connect 55xx/54xx or any power connect switch without username and password for ssh?
View ArticleN4064F GLC-BX SFP incompatible
Hi,We're just about to install 2 x Dell N4064F switches to replace our Cisco/Netgear switches.However we've run into an incompatibility issue using simplex/bi-directional/single-core SFPs (GLC-BX-U and...
View Articlepoor/terrible bandwidth on Dell N3024 switch
good morning allI have a the N3024 in a pretty basic configuration- there is a single Avid *** (SAN solution) with a single Myricom 10Gb card connected to the front 10Gb port on the N3024 -there is no...
View ArticleNew X1052P, Help
I just got a new 1052P. Installed it into the rack, plugged it in. Went through the setup wizard and gave it a name and IP. Then put my computer back onto the normal network settings, plug into the...
View ArticleIP SLA or VRRP for Dell 3024 on 6.2.1.6 ???
Replacing a Dell S4810 with a Dell 3024. The S4810 is able to provide some VRRP for IP SLA type preemptive fail over. I do not see IP SLA nor VRRP on the 3024 while running the latest firmware.Am I...
View ArticleBuying used Dell PowerConnect 3548 - Question
Hello!My family has a small business. We currently have an old Dell PowerConnect 2716 data switch. It's pretty old and we've run out of ports so I'm looking to upgrade this device.A local recycle shop...
View ArticleDont get routing between vlan Dell 3034 n
We bought 2 new 3024 n switches to replace our old 6224 switches.I have put in the configuration from the old switches we are going to replace, but i dont get the routing betweenVlans to work. I can...
View Article6248 - IP Phone and PC on same physical port - VLAN and Routing Questions
Our current setup:All user PCs are networked via 3 Powerconnect (stacked)VLAN 3 - PC data vlanVLAN 3 is assigned at the port levelAll user PCs are assigned an IP address within the 10.0.1.0/24...
View ArticlePort down...
Well this is awesome. I somehow managed to bump "sh" and then "enter" when I was in the config section for a port... and it shut the port down.I've tried "Set interface active ethernet 1/eXX", no luck....
View ArticleShow port configuration....?
I've perused the manual and online, and not found a command that displays the detailed configuration of a port(s). This is for a Powerconnect 34xx series.For example I'd like to know if a port is set...
View Articledoes Dell-PC2816 switch support native vlan ...? Not found any command in...
Hi All,does Dell-PC2816 switch support native vlan ...? Not found any command in user-guide/command-line-guide , can any one confirm...
View ArticleCan I configure a PowerConnect Switch/router without a Username/Password.
Intension of this configuration is to run a series of commands remotely using SSH WithOut a Username/Password on the switch;I have tried removing the username and password by connecting to the Console...
View ArticleLeap second on 30 of June 2015
Hi,Will PowerConnect devices be affected by the leap second on 30 of June?Specifically the following models:62486224RPS-6008132FThanks!
View Articlerouting from Vlan to a router/external through lyer 3 switch n3048
Hello , I have this scenario that im trying to implement , but unfortunately never worked ! I have enabled dhcp on my switch N3048 to give 10.10.10.0/24 to internal subnetI have 2 ISPs routers that...
View ArticlePCM8024-K links are up while switch is rebooting
Hey, guys!We are facing one very unpleasant problem. If you reboot switch M8024-K (for maintenance, for instance), link on blades goes up after few seconds, but there is no communication, because...
View ArticleN3024 switch
Hello,Can dell N3024 be configured to work as a dhcp server ? if yes how please.
View ArticlePower Connect 6248 RMON configuration
My Power connect runs on firmware: 3.3.1.10I am trying to collect RMON history on Interface 1/g42Done this:rmon collecttion history 1 owner "xyz" buckects 10080 interval 60When I show rmon history I...
View Article