Hi guys,
I try to set one interface of our mxl stack in switchport mode but so far without succes this is my configuration:
sever ip: 10.6.30.54 and 10.6.30.55
switch configuration
#show version
Dell Real Time Operating System Software
Dell Operating System Version: 2.0
Dell Application Software Version: 9.6(0.0)
Copyright (c) 1999-2014 by Dell Inc. All Rights Reserved.
Build Time: Sun Sep 28 10:02:15 2014
Build Path: /sites/eqx/work/swbuild01_1/build09/E9-6-0/SW/SRC
Dell Networking OS uptime is 17 week(s), 6 day(s), 18 hour(s), 49 minute(s)
System image file is "system://A"
System Type: MXL-10/40GbE
Control Processor: MIPS RMI XLP with 2 Gbytes (2147483648 bytes) of memory, cores(s) 1.
256M bytes of boot flash memory.
2 34-port GE/TE/FG (XL)
80 Ten GigabitEthernet/IEEE 802.3 interface(s)
4 Forty GigabitEthernet/IEEE 802.3 interface(s)
interface Vlan 4
description internal
ip address 10.6.30.56/16
untagged TenGigabitEthernet 0/1-32,41,44,49-52
untagged TenGigabitEthernet 1/1-16,41,44,49-52
no shutdown
interface TenGigabitEthernet 0/49
no ip address
switchport
no shutdown
interface TenGigabitEthernet 1/49
no ip address
switchport
no shutdown
TenGigabitEthernet 0/49 is up, line protocol is up
Hardware is DellEth, address is d0:67:e5:c1:63:77
Current address is d0:67:e5:c1:63:77
Port is present
Non-qualified pluggable media present, SFP+ type is 10GBASE-CU3M
Medium is Twinax Copper
Interface index is 27857153
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :d067e5c16377
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 7w0d6h
Queueing strategy: fifo
Input Statistics:
336922 packets, 30544128 bytes
99845 64-byte pkts, 237042 over 64-byte pkts, 0 over 127-byte pkts
35 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
237042 Multicasts, 99880 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
136346 packets, 8726144 bytes, 0 underruns
136346 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
136346 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 5d1h42m
TenGigabitEthernet 1/49 is up, line protocol is up
Hardware is DellEth, address is d0:67:e5:c1:63:77
Current address is d0:67:e5:c1:63:77
Port is present
Non-qualified pluggable media present, SFP+ type is 10GBASE-CU3M
Medium is Twinax Copper
Interface index is 42799361
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :d067e5c16377
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 7w0d6h
Queueing strategy: fifo
Input Statistics:
205362 packets, 21529697 bytes
793 64-byte pkts, 204569 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
204569 Multicasts, 793 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
136345 packets, 8726080 bytes, 0 underruns
136345 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
136345 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 5d1h43m
Interface Designated
Name PortID Prio Cost Sts Cost Bridge ID PortID
--------- -------- ---- ------- ----------- ------- -------------------- --------
Te 0/49 128.178 128 2000 FWD 0 32768 d067.e5c1.6379 128.178
Interface Designated
Name PortID Prio Cost Sts Cost Bridge ID PortID
--------- -------- ---- ------- ----------- ------- -------------------- --------
Te 1/49 128.234 128 2000 FWD 0 32768 d067.e5c1.6379 128.234
#ping 10.6.30.54
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 10.6.30.54, timeout is 2 seconds:
.....
Success rate is 0.0 percent (0/5)
#show vlan
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P - Primary, C - Community, I - Isolated
O - Openflow
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
o - OpenFlow untagged, O - OpenFlow tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged
NUM Status Description Q Ports
* 1 Inactive U Po1()
U Te 0/42-43
U Te 1/17-32,42-43
4 Active internal U Te 0/1-32,41,44,49-52
U Te 1/1-16,41,44,49-52
#show vlan brief
VLAN Name STG MAC Aging IP Address
---- -------------------------------- ---- --------- ------------------
1 0 1800 unassigned
4 0 1800 10.6.30.56/16
but when I set the interface in L3 mode I can ping the server, any hints ?