Hello Community,
i want to set up a Guest WLAN using 2 VLAN's.
Setup: IPFire, Dell Power Connect 6248, Netgear WNAP 320 Access Point
The Blue Interface on the Firewall tag all frames with the ID 15.
On the Switch near all Ports are untagged and in the native VLAN 1.
The "Guest-VLAN" has the VLAN ID 15.
Port Settings
G36: Trunk
G22: 
All untagged frames from the Native-VLAN 1 get the ID1 when they reaches Port 22.
VLAN Membership
In Native VLAN 1
In "Guest VLAN" 15:
So, on the Port 22 who is connected to the AP, the Frames with the ID15 (Guest) and the Frames who get the ID 1 should transmitted to the AP.
On the AP, I set up 2 SSID's.
The Staff-WLAN has the VLAN ID 1 and the Guest-WLAN the VLAN ID 15
But only the Staff-WLAN works. I don't get an IP-Adress when i connected with the Guest-WLAN.
Another Setup on the Access Point:
I'm a Beginner in this topic and English is not my favorite language, so please apologize little mistakes :)
Do you have any ideas?
Thanks. :)