Hi Experts,
I've set up the following configuration using PowerConnect 6224 switches:
PC A --- SW A --- SW B --- SVR A (via VLAN 2)
PC B --- SW A --- SW B --- SVR B (via VLAN 3)
I've set:
1. two vlan 2 access ports on switch A to connect PC A and SW B
2. two vlan 3 access ports on switch A to connect PC B and SW B
3. two vlan 2 access ports on switch B to connect SW A and SVR A
4. two vlan 3 access ports on switch B to connect SW A and SVR B
all using separate physical ports and switchport mode access.
This setup does not work, is it the correct behavior or I missed out something?
Cheers,
Elvin