Hello,
We are currently working with our 6248 Dell switches experimenting with sFlow.
We discovered that we are limited to Sampling 32 ports per switch/stack of switches
So we were trying to come up with the most efficient way to make use of the 32 ports that are available.
This being the first time working with sFlow, we decided to use sFlow to sampling from the channel-groups we setup.
Shortly configuring this, we discovered that our receiver was no longer receiving sFlow data. Upon doing a little bit of research we found that sampling ports that are apart of a channel-group (LAG) can be a bit tricky. I believe it had something to do with the exporting device including specific data for the receiver to properly analyse the data.
I was wondering if anyone has had any experience with this scenario? Or if anyone has some advice?
thank you