2 Dell connect 6224 on VLAN 50, but one of the web management interface is down
Dear team, We have 2 Dell connect switch. But strangely, only 1 web management interface is up and the other is down.LAG have been configured for them. And they are on the same VLAN, but for certain...
View ArticleWhat are the bare minimum commands to get a 3-switch PC6825 stack working...
I'm brand new to PowerConnect switches, although I am familiar with the concepts of VLANs, link aggregation, and spanning-tree.I'm on a deadline to get some new 6248's installed in our racks and have...
View ArticlePowerconnect 7000 series in-band versus out-of-band management
Hi all, I have four Powerconnect 7024's configured as two stacks: one stack is dedicated to iSCSI and the other stack serves my front-end network. I've got the iSCSI stack setup with OOB management...
View Articlevlan routing woes 7024
Hi,RE: 2 x PowerConnect 7024 switches connected together over 10G fiberI'm having trouble with routing traffic. 3 VLANs in total. I've got one vlan routing between switches over its own 10G trunk, but...
View Article5524 SFP+ direct attach cable requirements
I am wondering if the SFP+ direct attach cable requirements for the PowerConnect 5524 are posted somewhere. I am trying to connect this switch to an Intel X520-DA2 dual 10GBE card that is attached to...
View ArticleDHCP over 62xx switches and 28xx switches
I am in the process of implementing a VoIP system and am struggling with the network config. I have a mixed environment of 62xx series switches and 28xx series switches. I have created a VLAN for voice...
View ArticleRemove IP address on VLAN 1
I have a 6224P switch that I need to integrate with some HP switches. My existing setup uses VLAN 1 for the data network and VLAN 10 for the VOIP network. I've tried to remove ip address on VLAN 1 by...
View ArticleRed fan LED on Dell PowerConnect 2748
I have a Red fan LED on Dell PowerConnect 2748 that is out of warranty. I would like to be able to download a repair manual that will explain how to determine which fan is bad, how to order, and...
View ArticleNewbie VLAN problem
HelloI'm a student and configure switches is something new to me. I have recently bought 2 powerconnects 6224 (not new) and updated them with the latest firmware. I would like to configure them to set...
View ArticlePowerConnect 3524p (The MAC address is not valid. You must set it now! )Error
Hi, i have a dell 3524p. It powers up fine but promp message asking for mac address and keep asking password which i can't figure out. Please let me know if you can help. Much appreciate. Boot1...
View ArticleAccess List
Hi,I have Dell power connect 6224 switch. Created two Vlans in it VLan 5 and 10.Ip address given to vlan 5 is 172.16.0.35, 255.255.255.0ip address given to vlan 10 is 192.168.20.1 255.255.255.0routing...
View ArticleProblem connecting unmanged switch to powerconnect 2848
Hi, I have a problem trying to connect an unmanged switch to my powerconnect 2848.Everything is working fine, if I connect a desktop in 2848 I get ip from dhcp and can navigate normally, but if I...
View ArticleOSPF default config on 6224
We've got several Dell 6224 Switches installed and working. 2 of the network switches are connected and routing internet traffic. The routing protocol, OSPF, is in a default state as Admin mode...
View ArticleHow to create ACL for telnet/ssh/http/https to manage Dell PC8164
Hi there!I've created several VLANs on Dell Switch PC8164, but i want to restrict the management of the device, only to a number of IP or subnets.For example, i want to allow only subnet:...
View ArticleClik here to view.
PC 8132 (N4032) Vlan membership access via browser - not possible
Latest firmware v6.0.1.3, two member stackNo matter what browser (tried 4 different ones so far)All I get is spinning wheel
View ArticleHow to get crash log out of 8164F...
We have using two 8164F in stacking config, and want to investigate cause of some rare fail-overs seemingly caused by no visible factors. RAM log doesn't have much info, but there was something about...
View ArticleConnecting MD3600F directly to PowerConnect M8428-k FC ports
Hi friends...Can you please confirm if i can Connect MD3600F directly to PowerConnect M8428-k FC ports..?Beacuse i cant see any zoning config. for M8428k..?Thanks
View ArticleDell 6248 - Traffic shapping nightmare.
Hello Community,I am facing nightmares with my dell 6248 switches. I plan to use them as metro switches to offer dedicated internet access to my customers. I am using firmware 3.8.8.2 for all 5 (five)...
View ArticlePowerConnect 8132f: Problems with link (PORT_CBL_TABLE parity error)
Hello,sometimes there is a problem when we use a Dell twinax direct attach cable to connect two PowerConnect 8132f to each other.The following error apears on the console:<187> Feb 11 22:58:54...
View Article